Comparison of Preparation Methods of Co3O4-Fe2O3 Composite Powder as a Heat Storage Material and Study of its Morphological and Phase Evolution during Redox Reactions

Document Type : Research Paper

Authors

1 Assistant Professor, Department of Metallurgy and Materials Eng., HamedanUniverisity of Technology, Hamedan, Iran.

2 MSc, Department of Metallurgy and Materials Eng., HamedanUniverisity of Technology, Hamedan, Iran.

Abstract

In this study, Co3O4-15 wt. % Fe2O3 composite powder was synthesized by two methods including: A-simultaneous milling of oxide mixtures (0, 1 and 16 h) and B-separately milling of cobalt oxide (0, 1 and 16 h) and iron oxide (0, 0.5 and 7 h) and then mixing. Average particle size, particle morphology, iron oxide distribution, phase analysis, and heat storage capacity were studied by FE-SEM, XRD and thermogravimetry methods. It was found that preparation method has a significant effect on the above-mentioned parameters. The results showed that decreasing of iron oxide particle size and addition of it to cobalt oxide, increase the heat storage capacity of the material relative to as-received cobalt oxide. It was revealed that samples prepared by method A generally had lower heat storage capacity than samples prepared by method B. In addition, it was found that small-scale particle size of the composite may not necessarily improve heat storage capacity of the material, and spinel phase formation (Fe2O3.CoO) also is a key factor that has a great effect on decreasing the heat storage capacity.

Keywords


1-Silakhori, M., Jafarian, M., Arjomandi, M., Nathan, G. J. Thermogravimetric analysis of Cu, Mn, Co, and Pb oxides for thermochemical energy storage, Journal of Energy storage, 2019; 23:138-147.
2-Wu, S., Zhou, C., Doroodchi, E., Moghtaderi, B. Thermodynamic analysis of a novel hybrid thermochemical-compressed air energy storage system powered by wind, solar and/or off-peak electricity, Energy Conversion and Managemnt, 2019; 180:1268-1280.
3-Bohm, H., Lindorfer, J. Techno-economic assessment of seasonal heat storage in district heating with thermochemical materials, Energy, 2019; 179: 1246-1264.
4-Yan, T., Wang, C. Y., Li, D. Performance analysis of a solid-gas thermochemical  composite sorption system for thermal energy storage  and energy upgrade, Applied Thermal Enghineering, 2019; 150: 512-521.
5- Andre, L., Abanades, S., Cassayre, L., High-temperature thermochemical energy storage based on redox reactions using Co-Fe and Mn-Fe mixed metal oxides, Journal of Solid State Chemistry, 2017; 253: 6-14.
6- Abedin,A. H. and Rosen, M. A.A critical review of thermochemical energy storagesystems. The Open Renewable Energy Journal, 2011; 4: 42-46.
7- Pardo, P., Deydier, A., Anxionnaz-Minvielle, Z., Rougé, S., Cabassud, M., Cognet, P. A review on high temperature thermochemical heat energy storage.Renewable &Sustainbale Energy Reviews, 2014; 32:591–610.
8- Aydin, D., Casey, S. P., Riffat, S. The latest advancements on thermochemical heat storage systems. Renewable &Sustainbale Energy Reviews, 2015; 41:356–367.
9- Agrafiotis, C., Roeb, M., Schmucher, M., Sattler, C. Exploitation of thermochemical cycles based on solid oxide redox systems for thermochemical storage of solar heat: Part 2. Solar Energy 2015; 114: 440-458.
10- Siegel, N. P. Thermal energy storage for solar power production. Wires Energy and Environment, 2012; 1:119–131.
11- Kuravi, S., Trahan, J., Goswami,Y., Rahman, M. M., Stefanakos, E. K. Thermal energy storage technologies and systems for concentrating solar power plants. Progress in Energy and Combustion Science, 2013; 39:285–319.
12- Mahlia, T. M. I., Saktisahdan, T. J., Jannifar, A., Hasan, M. H., Matseelar, H. S. C. A review of available methods and development on energy storage; technology update.Renewable &Sustainbale Energy Reviews, 2014; 33 532-454.

13- Andre, L., Abanades, S., Flamant, G. Screening of thermochemical  systems based on solid-gas reversible reactions for high temperature solar thermal energy storage, Renewable &Sustainbale Energy Reviews, 2016; 64:703-715.

14- Carrillo, A. J., Moya, J., Bayon, A., Jana, P., Oshea, V. A., Thermochemical energy storage at high temperature via redox cycles of Mn and Co oxides. Solar Energy & Solar Cells, 2014; 123:47-57.
15- U.S.Department of Energy. Thermochemical heat storage for concentrated solar power.General atomic project, 2011; GA-C27137.
16-Muroyama, A. P.,Schrader, A. J., Loutzenhiser, P. G. Solar electricity via an Air Brayton cycle with an integrated two-step thermochemical cycle for heat storage based on Co3O4/CoO redox reactions II: Kinetic analyses, Solar Energy, 2015; 122: 409–418.
17- Singh, A., Tescari, S., Lantin, G., Agrafiotis, C., Roeb, M., Sattler, C. Solar thermochemical heat storage via the Co3O4/CoO looping cycle: Storage reactor modelling and experimental validation. Solar Energy, 2017; 144: 453–465.
18- Yan, T., Wang, R. Z., Li, T. X., Wang, L. W., Fred, I. T. A review of promising candidate reactions for chemical heat storage.Renewable &Sustainbale Energy Reviews, 2015; 43:13–31.
19- Block, T., Knoblauch, N., Schmucker, M. The cobalt-oxide/iron-oxide binary system for use as high temperature thermochemical energy storage material. Thermochemical Acta, 2014; 577:25-32.
20- Zhang, H.L., Baeyens, J., Degrève, J., Cacères, G. Concentrated solar power plants: review and design methodology. Renewable &Sustainbale Energy Reviews, 2013; 22:466 –81.
21- Nekokar, N., Pourabdoli, M., GhaderiHamidi, A. Effects of Fe2O3 addition and mechanical activation on thermochemical heat storage properties of the Co3O4/CoO system.Journal of Particle Science and Technology, 2018; 4: 13-22.
22-Nekokar,  N., Pourabdoli, M., GhaderiHamidi, A. Effect of mechanical activation on thermal energy storage of Co3O4/CoO system. Advanced powder Technology, 2017; 2(29): 333-340.

23-Nekokar, N., Pourabdoli, M. Isothermal redox kinetics of Co3O4-Fe2O3 composite as a thermochemical heat storage material, International Journal of Engineering, 2019; 32 (8), 1200-1209.

24-Hasanvand, A., Pourabdoli, M., GhaderiHamidi, A., Thermochemical heat storage properties of mechanical activated Co3O4-5 wt. % Al2O3 and Co3O4-5 wt. % Y2O3Ccomposite powders. Iranian Jouranl of Materials Science and Engineering, 2020, In press.
25- Hasanvand, A., Pourabdoli, M., Theoretical thermodynamics and practical studies of oxygen desorption from Co3O4-5 wt. % Al2O3 and Co3O4-5 wt. % Y2O3Ccomposites. Jouranl of Particle Science and Technology, 2019, 5 (1):20-30.